$200.00
Introduction to Statistical Process Control

 Recorded Webinar
 60 Minutes
 Refer a Friend
Introduction to Statistical Process Control

This webinar will introduce attendees to the foundations of statistical process control (SPC), including the effects of variation and accuracy on process quality. The definition of a Six Sigma process will be illustrated. Attendees will learn how to construct SPC charts that provide visual controls (easily understood signals) that tell production workers when the process requires adjustment to prevent the m..

$200.00
What to Do When It's Not a Bell Curve

 Recorded Webinar
 60 Minutes
 Refer a Friend
What to Do When It's Not a Bell Curve

Traditional statistical process control (SPC) and process capability assessment techniques assume that the critical to quality (CTQ) variable follows a normal (bell curve) distribution. This condition is fulfilled far more often in textbooks than in real factories, laboratories, and so on. If the statistical distribution is not a bell curve, estimates of the nonconforming fraction (defects per million oppor..

$200.00
A Leer, A Pat, A Joke, A Gesture, An Innuendo, A Kiss: Are You Prepared To Be the Next Social Media Blitz, Identified on #MeToo, or a Headline in the Newspaper?

 Recorded Webinar
 90 Minutes
 Refer a Friend
A Leer, A Pat, A Joke, A Gesture, An Innuendo, A Kiss: Are You Prepared To Be the Next Social Media Blitz, Identified on #MeToo, or a Headline in the Newspaper?

Harvey Weinstein, Matt Lauer, Charlie Rose, Al Franken, Garrison Keillor, members of Congress, and various State lawmakers have been accused of sexual harassment and/or sexual assault. But there is a difference between pulling one’s pants down in front of a female colleague at work and touching a woman on her buttocks during a photo op—isn’t there? What is that difference? Are both examples considered sexua..

$200.00
The Dynamic Control Plan

 Recorded Webinar
 60 Minutes
 Refer a Friend
The Dynamic Control Plan

Failure mode effects analysis (FMEA) and the control plan are both parts of advanced quality planning (AQP). FMEA, in fact, defines the control points or critical nodes of the control plan; process activities that must be controlled to ensure conformance of the critical to quality (CTQ) product characteristics. The dynamic control plan is a natural combination of the process FMEA and control plan into a sin..

Showing 1 to 4 of 4 (1 Pages)